(NT's) Spray Wand fix

Tim Lynch

New Member
Some of you may use the Spray wand Northern Tools sells. The brass 6 ft extention one. As they are great for deck refinishing using a shurflow or similar. One problem with them is the brass splitting at the end by the curve.

I have been using J-B Weld on a new one that split for god knows what! I never even got to use it! It was a back up unit.
So far so good the split was about 2 inches long. And have been shooting without problems.

Crossed fingers...

I used laquer thinner to clean then buffed it with some wet/dry 600 grit paper and cleaned again. A good coat of JB weld all around the neck not to thick. Seems to work well so far.

Hope someone gets a few new wands back in action.
 

Our Sponsors

Top