Search results

i bought a new pinlock extendawand a couple weeks ago. it was only 22 ft. when extended. i was told they don't make 24 ft wands anymore because a 22 ft wand is cheaper to ship. funny thing though, it is the same size as all of my old ones when not extended and the box is the same size too...

i found a company that will make just about anything you want when it comes to hose. cutandcouple.com. i hope this helps someone.

it's for my extendawand so the worst scenario would be a 23 ft wand. it would probably be easier than getting one from them. send me a price Mark.

does anybody know where to get custom length hose? i need a 1/4 inch hose 26 ft long w/ 1/4 in. male ends. duane

does anybody know where i can get advertising icons i can use on business cards or websites. like little pressurewasher guys or similar. thanks

does anyone know if rebuild kits are available for ar unloaders. i replaced one on my alkota a couple years ago and still have the old one. there isn't much to them.

WW, i use extendawands. i couldn't live without them. i have a 12 ft. and a 24ft. the less i use the 24ft the better. i use the 12ft everyday.

my burner went out friday around noon. i called Mark as soon as i knew what i needed. monday afternoon i'm up and running with the new part. thank you Mark! duane

i've had luck with " wesleys bleech white"

jim you should be able to find an x-jet for just under $100. i go through 1 or 2 a year. they are overpriced in my opinion. but still worth every penny. duane t

i had a similar problem. the burner assembly came loose and was slightly out of alignment in the tube to the coil. if i lift up on the burner and blower assembly it ignites. i figured it was from bouncing down the road. there is a screw on both sides of the tube. these came loose too. i hope...

the new fuel pumps didn't help. the shop i use said it may be a vapor lock too. i guess i don't need to worry till july or august.

has anyone had problems with a 16 hp vanguard not getting fuel to carb? i'll start off fine on a hot day and after the motor gets hot (2or3hrs) the fuel filter is running dry. i can't see any fuel movement at all through the clear filter. at startup there's plenty of gas visible.on cooler days i...

Spend the $35 bucs. You should have a safety can anyway.

Ged go to your nearest masonry supply store. ask for a gallon of Sureklean 600 detergent. read dilution directions and safety precautions. i use it every day. e-mail me for any questions. duane

jlw, try drilling new holes in the shaft. i thought i needed new pinlocks but the holes were worn. i have four extendawands. i use at least one of them every day i work. i wouldn't trade for anything but i haven't seen a coress either. the guy used to be prompt and reliable but lately i've had...

I've had some luck with Wesley's Bleech White and a scotch pad. i've tried all other suggestions. this one works best for me. duane

stephen howland from extendawand told me last year they were coming out with a new mounting system for the gun. i haven't followed up on it yet but i will. the nuts pulled out of my pole assembly and they sent me a new pole assembly. i still want to repair my old one. i will let you know what i...

i had this problem last year. i was going to replace the pinlocks($50 each)until i looked at the holes. they were worn and oblong. i drilled new holes where needed and cleaned out the old holes with the drill bit. it works like new. duane

go to your local sand,gravel, block and brick supplier.. duane