I would appreciate any advice you folks might have. I have looked at some current treads and don't see my exact problem, so here it is:
When I start my machine it idles a little rough, but can stay running on its own fine. In fact when I'm not gunning it isn't obvious there is a problem (it almost sounds like a small timing problem). However, once I pull the trigger the machine can't produce any real horsepower. The engine sounds like it struggles, and it wavers. The pressure goes up and down, but even at its strongest the psi is very low. I looked at it closely with the trigger pulled and the thing I noticed was the wire and spring under the throttle bar were moving back and forth.
Any ideas? Thanks in advance.
Also... until this happened the machine was working perfect. This whole year I have been keeping very close tabs on it. I did just change my tips, but would that do this???
When I start my machine it idles a little rough, but can stay running on its own fine. In fact when I'm not gunning it isn't obvious there is a problem (it almost sounds like a small timing problem). However, once I pull the trigger the machine can't produce any real horsepower. The engine sounds like it struggles, and it wavers. The pressure goes up and down, but even at its strongest the psi is very low. I looked at it closely with the trigger pulled and the thing I noticed was the wire and spring under the throttle bar were moving back and forth.
Any ideas? Thanks in advance.
Also... until this happened the machine was working perfect. This whole year I have been keeping very close tabs on it. I did just change my tips, but would that do this???