onecallpowerw
New Member
Now ya talkin !!
-
Check out this this free event.
Cheap Remote Control
- Thread starter HI-Pressure
- Start date
O
OrangeCrest
Guest
I found a site that might interest some... I have wanted to do this for the longest time. Turning the burner on and off remotely would save a load of fuel also...
http://www.propane-generators.com/wireless_remote.htm
Let me know what you think...
http://www.propane-generators.com/wireless_remote.htm
Let me know what you think...
Robert you would still need a clutch on your pump.
One thing I found regarding tools of the trade........ cheap is not always the best.
The remote mentioned is built for the mobile washer
also it is h20 proof
Thats the important thing
My remote for the unit takes on so much abuse .......... I dropped it millions of times , It landed in a bucket of oil, It was dropped from a ladder while on a roof , And it still works like it was new.
When I first bought it I had a minor problem , They sent me a complete unit and a better one then what I had @ no additional charge.
One thing I found regarding tools of the trade........ cheap is not always the best.
The remote mentioned is built for the mobile washer
also it is h20 proof
Thats the important thing
My remote for the unit takes on so much abuse .......... I dropped it millions of times , It landed in a bucket of oil, It was dropped from a ladder while on a roof , And it still works like it was new.
When I first bought it I had a minor problem , They sent me a complete unit and a better one then what I had @ no additional charge.
MODEL RWC-22204D radio link controller
Designed for 1-step hot water PW with gas engine, clutch drive to pump, engine stop. DC power switch for control of 12 VDC to boiler. (ACC-1712) Mobile mount. Vibration isolation mounting provided. Mounting hardware is included. NEMA 4 rated fiberglass housing with windowed door. Internal power supply (12 VDC source). Universal adapter (ACC-1513) for machine interface, with 15 feet of control cable. A small amount of electrical wiring is required on the PW machine Whip antenna is remote mounted on stainless steel mount bracket. (ACC-1222) 15 feet of coaxial cable. External audible annunciator is high volume horn. 15 feet of cable is provided with 2 pin Amphenol © connector for connection to control cabinet. Isolated relay contacts for PW machine control. 7 Amp rating, low voltage.
This is the one that I have !!
And the one Mark should work on price.
Designed for 1-step hot water PW with gas engine, clutch drive to pump, engine stop. DC power switch for control of 12 VDC to boiler. (ACC-1712) Mobile mount. Vibration isolation mounting provided. Mounting hardware is included. NEMA 4 rated fiberglass housing with windowed door. Internal power supply (12 VDC source). Universal adapter (ACC-1513) for machine interface, with 15 feet of control cable. A small amount of electrical wiring is required on the PW machine Whip antenna is remote mounted on stainless steel mount bracket. (ACC-1222) 15 feet of coaxial cable. External audible annunciator is high volume horn. 15 feet of cable is provided with 2 pin Amphenol © connector for connection to control cabinet. Isolated relay contacts for PW machine control. 7 Amp rating, low voltage.
This is the one that I have !!
And the one Mark should work on price.
onecallpowerw
New Member
Hey Mark,
Went to your site yesterday and could not find ball valves. Do you still sell them ?
Went to your site yesterday and could not find ball valves. Do you still sell them ?
O
OrangeCrest
Guest
Hey Dan...
How much is that one going for, $1,000?
O
OrangeCrest
Guest
I just got this e-mail from that site:
**************************
Hello,
Yes, the WRCS can start any engine. For cold start you may want to consider
our choke actuator. The system comes with 4 circuits; 1 latch for on/off, 1
momentary for starting, 1 auxiliary momentary (good for use with the choke
actuator), 1 auxiliary latch which could be used for your burner on/off if
it is controlled by an electrical switch.
Discounts may be available based on the quantity. You could also save by
ordering the WRCS less the install pack that has the additional relay,
toggle, fuse, etc.
Thank you for your request.
John
*************************
**************************
Hello,
Yes, the WRCS can start any engine. For cold start you may want to consider
our choke actuator. The system comes with 4 circuits; 1 latch for on/off, 1
momentary for starting, 1 auxiliary momentary (good for use with the choke
actuator), 1 auxiliary latch which could be used for your burner on/off if
it is controlled by an electrical switch.
Discounts may be available based on the quantity. You could also save by
ordering the WRCS less the install pack that has the additional relay,
toggle, fuse, etc.
Thank you for your request.
John
*************************
O
OrangeCrest
Guest
That is for the high rollers... I wish I could afford the Cadillac of remotes like that, OUCH!!
Walt Graner
New Member
I have an old remote unit, took it off about 5 years ago anyone want to buy it?
I think it costs about $ 700.00
We used it for a while and then when we changed rigs just never put it back on.
I think it costs about $ 700.00
We used it for a while and then when we changed rigs just never put it back on.
onecallpowerw
New Member
Walt, whats your askin price for that old 5 plus years remote. Just joking. But, I would take a pic and price it.
B.E YOUNG Sr
New Member
I bid $100.