bling bling
New Member
i started my washer yesterday but after a few minutes it shut off, the engine just turns over but wouldn't start so i isolated the engine by unplugging the low oil shut down wire still nothing,so i replaced the coil i believe some call it the armature,its the part that attaches to the side of the fly wheel with two spark plugs wire attached.after i replaced it,it started for a few minutes but shut down again.the engine is a 18 hp b&s ,i set the armature gap at .10/thousandth ,is this the correct gap? it also has new plugs.i checked and its getting gas.could someone please help me out on this one.thanks for any info offered.
------------------
Jerome Ware
Master Clean
------------------
Jerome Ware
Master Clean