I have a mitm hds 3505, washer, i have had very little problems out of it until the other day when the burner quit working, i traced it back to the ignitor not working replaced that, then 3 hours later it actually shorted out and popped off the machine. Since then i have traced the problem back to a voltage issue. I can adjust the motor to run around 130 volts with no load on it, pull the trigger and it dropps to around 80 volts which is way to low, then let off the pressure and it jolts up to 140-160 volts which is what is causing the ignitor to fry. Just hoping for a little direction, i hate admitting defeate, but i am almost ready to take it in. Any help would be greatly appreciated.