Aplus
New Member
What water temps do you guys typically use. Do you vary it depending on the application?
The reason I ask is that I've found 180 degrees to be a good all around temp, and a full tank of diesel will last about 10 hours. I use this temp for concrete, building, and vehicle cleaning.
I did a job a few weeks back cleaning restaurant equipment, and I cranked the burner full tilt, to 194 degrees. I went thru a full tank in 7 hours. The extra heat really made a big difference removing the slimey grease that covered most everything. The restaurant equipment was from a Mexican restaurant, so I imagine there was a lot of frying at high temps going on, creating splatter everywhere.
So what are the opinions..................
The reason I ask is that I've found 180 degrees to be a good all around temp, and a full tank of diesel will last about 10 hours. I use this temp for concrete, building, and vehicle cleaning.
I did a job a few weeks back cleaning restaurant equipment, and I cranked the burner full tilt, to 194 degrees. I went thru a full tank in 7 hours. The extra heat really made a big difference removing the slimey grease that covered most everything. The restaurant equipment was from a Mexican restaurant, so I imagine there was a lot of frying at high temps going on, creating splatter everywhere.
So what are the opinions..................