Search results

Blow dryers get real hot... I've had good luck with a hand held steamer. I don't have to worry about burning my fingers and I can use a plastic squeege to lift the edges. If the piece is over 4 inches wide, try slitting it into strips.

I had trouble with my tank (outlet about 3" above factory water inlet height) feeding enough water when the level was low. I replumbed the feed line with 7/8" ID line and replaced the filter with a larger one. After this, I realized the small line (3/4") was reducing my flow at all times. I...

I have added a male hose end to a pump up sprayer and use that to push antifreeze through the lines, pump and hoses. I blow out the water first with compressed air. Do this to your water (garden hoses) too. I start with pure antifreeze. It will pick up water as it goes into the system. I reclaim...

injecting anti freeze I use auto anti freeze like most of you do, but I pump it through the machine (including the heater and hoses) with a modified pump up sprayer. I cut the hose, removing the control valve, lance, etc. and added a male water hose connector. I mix the antifreeze, load the...