Recent content by OKwasher

Does it have to sit on the concrete for a long time, or is it just soak aggitate then wash. Thanks for the input, I'll give him a call tomorrow. I haven't been real happy with the so called "green" chemise I have used in the past.

I havent been on here in a while, been busy working 2 jobs, I mainly do fleets, but I also do concrete cleaning on the side. I recently got a call from one of my good customers asking if i can clean a driveway they leaked oil on. I can usally take my degreaser and spray it on the spots...

take a pair of vise grips and clamp off the unloader return hose while pulling the trigger, if pressure goes up you may have a unloader problem, mine did the same thing, no vibration, ran great, but was low on pressure, i replaced the packings in the pump and one ceramic plunger and did a coil...

that is the direction i have been leaning,but i just did a compression check on it (120psi) adjusted the valves, new plugs, fuel line and filter, air filter, since the problem has started. A few months back, my pump lost a little presure, so i rebuilt it, and had to replace 1 ceramic plunger...

I have a mitm hds 3505, washer, i have had very little problems out of it until the other day when the burner quit working, i traced it back to the ignitor not working replaced that, then 3 hours later it actually shorted out and popped off the machine. Since then i have traced the problem back...

I am not sure where your from (FCPWLLC), but there are so many small washing companies here in okc that, I would never thanks about fireing someone. BIODUDE I live a little south of okc, what I am working on is switching everyone I wash over to the two step process. most my accounts I was weekly...

I guess know one else is two stepping, I am not wanting anyones secrets, just would like to get a few suggestions on what else I could try.

I am not new to the two stepping process, just never persued it because of the added cost, until one of my bigger clients started complaining a little bit about, his trucks, I showed him the two step process and he was blown away. I used citric acid, and followed with a degreaser truck wash...

Let me clear it up for you. I was refering to my 40deg quick connect tip on the end of my wand as my high pressure tip. when I pull it out there is no pressure, then the injector will work. also I have already gauged the crimps, and that is not it. the injector is flowing the right direction. I...

I have been having trouble for the past few months with my down stream injector, not working, I used the same injector for 5 years w/ 150' of hose. I just recently started having problems with it working, so I bought a new injector, still the same problem. I noticed it after I bought new hoses...

one of my suppliers yesterday showed me a foaming tip, it looked neat, but does it work? it was all stainless, and look very nice, he said he would sell it to me for $300.00. I was just wanting to know if any one is using them, and how well they work. thanks

thanks for the input, I think it may be a flow problem, I can take the nozzle out of the gun and it will work. I am using a 2.3 injector valve. just thought i would see if anyone has had the same problem. thanks

I am having a problem with my injector valve, it won't pull and chemical. I have bought three in the last month, they will work for a while then quit. I have a 3500 psi 5.6 gpm, M-T-M . I was talking to the company that sold me the unit, and they said they have had this problem before, try...

only way to go is MI-T-M. check there web site.

FLEET WASHIN, you AINT GOT to have a degree to go pressure WASHIN. HA HA HA.